Balance Weights
Lead Free weights for Steel Wheels Section, for Tyrebay Direct's Range of Lead Free weights for Steel Wheels products ...
13 products to view
 |
Lead Free Weights for Alloy Wheels Section, for Tyrebay Direct's Range of Lead Free Weights for Alloy Wheels products ...
13 products to view
|
Check out our fantastic savings on our high quality self adhesive ...
12 products to view
|
Wheel balance weights from Rubber Vulk via Tyre Bay Direct offer precision wheel balancing at great value prices. Tyre Bay Direct are proud to be exclusive UK & Ireland suppliers of Rubber Vulk wheel weights.
Application of Adhesive weights
1 – Preparation work
Rotate the tyre and determine the wheel imbalance in both planes. Ideally the weight, rim and ambient temperature should be around 15 degrees centigrade as this enables the adhesive backing to perform at its best. Clean the rims with an appropriate cleaning agent to avoid grease and silicone residues on the rim.
2 – Removing the protective backing
Having identified the weight position to the rim, peel off the protective backing without touching the adhesive.
3 – Assembling the weight
Now press the weight to the rim from the middle towards the outer edges. The pressure should be applied for at least 20 seconds. After assembly 80%-90% of the final adhesive force is achieved after approx 24hrs. Full adhesive force is achieved after 72 hrs.
Application of Adhesive weights
1 – Preparation work
Rotate the tyre and determine the wheel imbalance in both planes. Ideally the weight, rim and ambient temperature should be around 15 degrees centigrade as this enables the adhesive backing to perform at its best. Clean the rims with an appropriate cleaning agent to avoid grease and silicone residues on the rim.
2 – Removing the protective backing
Having identified the weight position to the rim, peel off the protective backing without touching the adhesive.
3 – Assembling the weight
Now press the weight to the rim from the middle towards the outer edges. The pressure should be applied for at least 20 seconds. After assembly 80%-90% of the final adhesive force is achieved after approx 24hrs. Full adhesive force is achieved after 72 hrs.
